Clean Motion is presenting a biocomposite enhanced pod where the roof-rear body part has been made out of Jute in a research project. Juteborg AB, a jute Design System & Solution provider was the initiator, with the aim to replace glass fiber with the natural fiber of jute. Co-partners in the project are SwereaSICOMP and Ljungby Komposit and the project is partly financed by Vinnova/Lighter. The research result will be shown and presented on Thursday the 31st of January at Lindholmen Science Park in Gothenburg. Clean Motion and Juteborg is presenting a Zbee with jute fibers in one of the body parts. The roof rear part of one Zbee has been produced with jute fibers instead of glass fibers. It is the result of a research project co-founded by VINNOVA under the Lighter umbrella. A demonstration vehicle has been built to enable the evaluation of the body structure in real life conditions. With the result of this project Zbee could have the potential to increase its sustainability throughout the lifecycle if the use of biocomposite is implemented. Clean Motion will look into further development on jute, however, factors as scaling and raw material refinement will have to be done in order to fully evaluate the material. One part of the project is to evaluate the result in the demonstration vehicle, where Clean Motion and Juteborg will invite professionals and media into discussions and test drives at the ‘eCon’, on the top of Nordstan in Gothenburg.