Aerometrex Limited announced the key developments and new product release for its MetroMap program. MetroMap is Aerometrex's aerial imagery subscription service and is one of 4 business units within Aerometrex, the others being LiDAR, aerial photo contracting and 3D modelling. The inclusion of 3D models into the same web browser interface as the 2D aerial photo presentations is a major technological step forward providing an improved customer experience and increased efficiency. This has been enhanced by speed improvements in the 3D viewer which enable the 3D data to be refreshed quickly. A range of measurement tools has also been included for 3D modelled data including 3D measurement vector and area measurements, and coordinate, height and slope point measurements. Further tools are in development which will continue to enhance the MetroMap product offering. These facilities provide a basic introduction to the use of 3D modelled data, which can be extended with further applications and tools in dedicated third-party 3D software. These new tools in addition to the existing product suite will broaden the addressable market for the Company whilst reinforcing Aerometrex as a technical leader in this industry. MetroCam is a new aerial camera system designed by Aerometrex's technical team and built in the USA by a specialist camera manufacturer. Aerometrex holds provisional patents for the camera system. MetroCam enables highly efficient imagery capture from Aerometrex's existing fleet of aircraft. The advantage of high-flying cameras is to avoid high-traffic airspace over metropolitan areas, whilst still producing very high-resolution imagery. MetroCam will produce 5cm imagery at the same flying height typically used to generate 7.5cm aerial imagery. At 5cm pixel size, MetroCam resolves 36x more pixels per unit area than the highest-resolution commercial satellite imagery.